Worktop for 1 Module


Worktop with opening to fit the sink, module to be applied above 1 DEA module (90 or 110 series).

The worktop is made of 0,07 inches (2 mm) thick sheet metal folded four times, welded in the corners for additional reinforcement and of 2 omega bars along the entire length of the module. The bars can also be used to pass piping and power cables.

The worktop is covered in scratch-proof ABS or DTC to make it resistant to scratches, mineral oils, fuels, acids, etc.

All the components are epoxy powder coated.

Furthermore, there are pre-cuts in the shorter sides that can be easily opened during the installation phase in order to feed in oil pipes, electrical cables, water and air hoses, etc.

installed in
  • Auto Repair Shops (mechanical, diagnostics, tyre/wheel alignment, pre-delivery, receiving, engines and transmission areas)
  • Motorcycle Repair Shops
  • Body Shops (pulling, dismantling, pre-delivery, receiving areas)
  • Workshops
  • Industrial Facilities
Photo and video gallery